CrackMaster PF Type IV
Meets Ohio DOT, type IV specification. Contains approximately 2% polyester fiber content. Designed for use in oil-jacketed kettles. Ideal for use on roads and highways. Remains flexible in all climates.
50 lb. box with two 25 lb. cubes per box.
Use the following chart as a guideline for estimating material requirements (based upon pounds of material needed for 100 feet of cracks):
|Crack Width||Depth||lbs. / 100 ft|
NOTE: The above coverage rates are only a guideline. Actual material usage may vary due to width of application and thickness of material above pavement surfaces.
CrackMaster PF Type IV is a single component, hot applied polymer modified crack and joint sealant with polyester fibers. When melted and properly applied it forms a resilient crack sealant for both asphaltic and cementatious pavements. CrackMaster PF Type IV forms a lasting seal that resists tracking in warm climates.
CrackMaster PF Type IV is designed to seal expansion joints, longitudinal and transverse cracks, joints between concrete and asphalt shoulders, and random cracks in both asphalt and concrete pavements.
Use material as supplied. Do not blend with other materials. After CrackMaster PF Type IV is melted it should be agitated or recirculated.
Apply heated CrackMaster PF Type IV using either a pump and wand system or a pour pot. For best results the sealant depth to width ratio should not exceed 2 to 1 (i.e. 2-inches deep to 1-inch wide). The cooled sealant height should not exceed 1/8″ above surrounding pavement. Using a sealing shoe or squeegee, band the material 2 to 3 inches wide over the crack.
Protective apparel is recommended with application of CrackMaster PF Type IV. The extremely hot material will cause severe burns on contact with skin. OSHA Safety Regulations require workers to wear the following types of safety attire (see current OSHA/Safety Regulations for additional information): Hard hat with face shield; long sleeved shirt buttoned at the wrist; heat resistant gloves; long, cuffless pants; and safety toed work boots. Make certain all area around melter is clear of all debris and flammable materials. Avoid breathing vapors. Use with adequate ventilation.
Wash tools in water before material dries.
|Unit Size||Unit Weight|
|50 lb. Box||50 lbs.|